skip to main |
skip to sidebar
Finally, I had an opportunity to make a time-lapse of an orchid blooming. This is a learning process and the video is far from perfect.
The frames were taken at five minute intervals and next time I will try ten minute intervals. Also, I will place the setup in a grow tent to control auxiliary lighing in the basement from affecting the video lighting.
All of the above being said, it was an enjoyable project.
This is what the orchid looks like up close, fully opened.
Potinara Love Love 'Yellow Bird', a medium/smaller sized cattleya. I waited a year for this one to bloom, the flowers will last about three weeks and then it is back to waiting.
The topic at this month's meeting of the Northeastern New York orchid
society meeting was growing orchids using a semi-hydroponic method. It
is a simple inexpensive method of growing orchids and once the plant is
established it is virtually impossible to overwater the plant, as it
will be accustomed to growing in water.
You can use any container without holes in the bottom, however, I prefer
clear plastic food containers so I can see what the roots are doing,
and, more importantly, I can see when to water/feed.
Two 1/4" holes are drilled about 1" above the bottom of the container to
form a well. Most growers use expanded clay pellets to grow the
orchids, so that is what I am using as I also have a lot of them
available.
The pellets are pre-moistened and added to the container so that it is a
little more than half full before the plant is added. The plant is not
adapted to growing in liquid yet, so you want any roots left on the
plant to be above the bottom not touching the liquid.
It is best to start with a young plant that does not have a large
established root system. Before placing the plant in the container any
dead or damaged roots should be removed, as they will rot. The plant is
placed in the container and the pellets are added to fill around the
plant up to the brim.
At that point, I place a strip of tape over the holes and fill the
container with a quarter strength nutrient solution and let the plant
soak in the solution for an hour. After an hour I remove the tape and
let the liquid drain from the container, leaving the remaining liquid in
the well.
That's it, you are good to go. The pellets will wick liquid up to the
plant from the well. When the liquid in the well is almost gone I
replace it with more quarter strength nutrient solution and let it
overflow. On every fourth cycle, I flush the container with clear tepid
water to remove excess salts from the pellets.
As a trial, I have identical plants, one growing in bark and one
being grown semi-hydroponically, and it should make for an interesting
comparison.
There are a lot of videos on growing orchids using this method on youtube.com if you are interested in trying to grow orchids this way.